Jazz GAS 60
“We come from the land of the ice and snow…”
Trademarks: Typical warm tone. Smooth attack.
Styles: Rock'n'roll, blues, rock, funk, fusion, pop
Output: Medium - High
Retail price: 100 Euros (without VAT) per pickup
Our 60's style JB pickups are for the traditional clean, yet warm, mellow Jazz Bass sound. They support balanced playing styles, offering huge dynamics and smooth attack, due to the beveled top rods. Also available as a set. The neck pickup is RW/RP for hum cancellation when both pickups are in operation.
Neck Rdc range 8,9 kOhms Neck Resonance frequency 6,5 kHz Bridge Rdc range 9,6 kOhms Bridge Resonance frequency 6,0 kHz Rod magnet alloy A5 Rod diameter 0,187" Rod top Bevel Winding wire (AWG, Coating) 42 Heavy PVA Hookup wire AWG 22 Cloth braided
For the proper installation and wiring of your GAS Pickups, we strongly recommend letting a professional luthier or electrician perform this job in order for the pickups to be installed correctly and with no damage, which would harm the pickup’s functionality and warranty.
All GAS Bass Singles are delivered with plastic covers (you may choose between white, cream, and black, or a combination of them, in case that you order more than one pickup), proper height adjustment screws, and springs (or rubber tubes).
GAS Bass Singles come with two cloth hookup wires, a black and a white one. In the case of a set, if the neck pickup is RW/RP there will be a yellow wire instead of the white one. Usually the black wires will be grounded, while the white and yellow ones will go hot. However, if you install a GAS Bass Single along with pickups of other brands on the same guitar and face out-of-phase problems when operating with them, just swap the black with the white (or yellow) wires. For the desired wiring diagram of your bass guitar, please refer to the dozens of specialized websites with such diagrams, depending on the desired configuration.
Pickup height or string distance
There is a lot of conversation on this item. The fact is, there is no absolute guidance for a generic pickup height adjustment! The distance of a pickup to the strings is dependent on countless factors, such as pickup output, pickup position, string gauge, the guitar itself, the guitarist’s overall playing technique (string hitting, etc.), and the musical styles that are about to be covered. In the case of a pickup set, usually the pickup height is adjusted so all pickups show a similar output level, but this is not a rule. Our recommendation: The desired pickup height adjustment is a procedure that may last longer than you think; just start with a generic distance of 3mm on the E and g strings and repeat the procedure (adjust, play, listen, re-adjust) until you are satisfied. Don’t forget to adjust in small steps (e.g., one full turn of the height adjustment screw each time) in order to easily come back one step if you are not happy with the new situation. And, trust us, if you just repeat the whole thing a couple of weeks later, you will probably find yourself re-adjusting the height again. It is something that each musician should go through by himself.
GAS Bass Singles are direct replacements for Fender® Precision®, Jazz Bass, and PJ bass guitars and similar models. The pickups dimensions (including pickup covers) are as follows (sizes in mm):
Are GAS bass pickups direct replacements for the original pickups?
Yes, however, sometimes the covers might be different since there is no official size for these, and small differences might occur.
Are GAS bass singles also available as a PJ set?
Yes, any P-GAS and Jazz-GAS bridge pickup combination is available.